Roofing Contractor in Palm Coast, FL

The Intracoastal Waterway runs the full length of Palm Coast, and the salt does not stop at the seawall. Onshore wind carries it across the C and F sections, over Palm Coast Parkway and well past Belle Terre. On a roof it shows up as rust on fastener heads, pitting on cheap flashing and galvanized drip edge, and shingles that shed granules faster than the same shingles would an hour inland.

A house on a canal in Palm Harbor gets a different material list than a house in Seminole Woods, and the difference is mostly in the metal: the panels, the trim, the fasteners and the flashing all have to be chosen for salt.

Palm Harbor, the C and F sections north of Palm Coast Parkway and east of I-95, was the first neighborhood ITT built, and it holds the saltwater canals that run out to the Intracoastal. Those are the houses closest to brackish water, most of them block and stucco from the 1970s and 1980s with low hip roofs, a screened lanai and a dock out back. Wind comes across open water with nothing to slow it, so ridge caps, rake edges and the corners of the hips take the worst of every storm.

Indian Trails (the B section, between Belle Terre Parkway and US 1) and the P section around Belle Terre sit farther from the water but still inside the salt zone. West of I-95, in Lehigh Woods, Pine Lakes, Seminole Woods and up in Matanzas Woods, Palm Coast turns into flat pine country with houses mostly built after 2000, tall gables, lots of valleys, and a screened pool cage bolted to the back wall under the roof line. Cages are the first thing a hurricane takes, and when one goes it pulls fascia, gutter and sometimes the roof edge with it. Our roof replacement work in every section starts with a tear-off to the deck, because plywood that has been under a leaking roof and salt air for forty years needs to be seen before it is covered again. Juan will tell you when a roof repair is all you need.

Metal roofing is what we do most, and Palm Coast is where the material choice matters most. Tri County Metals, the Florida manufacturer we install for as a factory trained installer, makes a Coastal Defender finish system: a 70 percent PVDF paint on aluminum panels, meant for roofs within 1,500 feet of the coast or of a salty or brackish body of water. That covers every canal lot in Palm Harbor and everything along the Intracoastal. Aluminum does not rust the way steel can where a coating gets scratched, and the PVDF finish holds its color through the sun. It is backed by Tri County Metals' limited paint and finish warranty.

Farther inland, in Pine Lakes or Matanzas Woods, a 26 gauge steel 5V or a TCM-LOK standing seam in the Max Defender finish is usually the right call. Standing seam hides the fasteners under the seam, which is one less place for salt to start. Panels from Tri County Metals carry Florida Product Approvals in the FL 36904 family, approved for use across the state, including the Miami-Dade high velocity zone.

Palm Coast has been hit from the ocean three times in a decade. Hurricane Matthew ran up the coast in October 2016, tore shingles and some whole roofs off oceanfront houses, and left 11 homes destroyed and around 500 damaged in Flagler County. Ian in September 2022 chewed up the dunes, and Nicole six weeks later came ashore with the beach already gone, flooded 218 Flagler homes and dropped sections of A1A onto the sand. Those storms are why we push wind-rated roofing and a sealed secondary water barrier on every Palm Coast job.

After a storm we handle storm damage restoration: photos, a written scope, meeting the adjuster. Palm Coast is part of our service area, which also covers St. Augustine up A1A and Daytona Beach to the south. If a new roof has to wait on a budget, our financing page lists the Regions Bank plans available through EnerBank.